Simplicity is important, especially when you face other challenges every day.
Clean hitchingOn all models, you have a simple headstock with cross beams where you adjust the plumb mechanically by a screw. You can also manually lock the plough for transport mode.
Robust beamsAll Prima beams are reinforced (except Prima 40). This gives them greater resistance to twisting, bending and impacts.
Multi-position AdjustmentTo adjust the working width, a pin-and-hole system allows you to change the angle of each element. You can then work from 12 to 22’’ depending on the inter-body spacing and Prima model.
Prima 70 SuspensionAs an option on this model, you can choose a suspended headstock in order to minimise the load of your tractor’s lift. You gain in comfort and your equipment lasts longer.
Simple adjustmentsYou adjust the vertical plumb with a stop screw. You set the tilt using a mechanical tie rod. You control the depth by the wheel and the coupling.
Your plough is set.
Hydraulic realignmentWhen in-furrow models with more than 4 bodies are turned, a hydraulic cylinder realigns the plough so that it does not touch the ground.
Prima 40, 50 & 70 in-furrow offsetYou can adjust your offset by means of a multi-position system. This means you can have very short and strong mounted ploughs. It transfers as much load as possible to the tractor. Grip is improved and you use less fuel.
Prima 70 on-land & 80 on-land offsetThe offset management on these two models allows you to work on-land with tractor tracks up to 3.5 m wide.
Adding or removing a bodyDo you plan to change your tractor one day? For one with higher power? Or lower? Remember, you can easily add or remove a ploughing body. Don’t forget to specify this when configuring your mounted plough. This means that you do not have to change ploughs if you change tractors.
Available in front ploughThe Prima 70 plough is also available as a push plough for hitching onto the front linkage of the tractor. It brings a load transfer on the front and improves the grip of your tractor.